Search
View: 315|Reply: 0

Brushless Gear Motor

[ Promote this link! ]

6

!threads!

0

Friends

20

Money

member

Rank: 1

Post time 2022-6-14 11:19:26 |Show all posts
Using effectively the role of the maintenance of the motor reducer, reducer accept larger during operation torque, overload when delivered to the motor as long as the load divided by the value of reduction ratio. To save the cost, if directly by the damage of the motor bear may be provoked. In overload very big slow down in time to be damaged, and reducer only needs to change the spare parts will be able to restore to use, cost is relatively low, if the motor directly damage repair is relatively slow, cost is high.
Effectively reduce the moment of inertia, reducer can timely Brushless Gear Motor start-stop control, variable speed. Through reducer increased torque is equivalent to increase the input power, also can reduce the input motor power (place) in the demand speed, than ordinary condition motor reducer is expensive, so think reducer must be used.
Can effectively save energy, the use of motor reducer to satisfy current output torque to reduce a lot. Use reducer can effectively reduce speed and increase torque of the motor, and according to the motor to output the corresponding reduction ratio. Effectively reduce the load moment of inertia of the motor, the numerical aspects of inertia is the square value of reduction ratio of different motor inertia values are different.
There are different types of reducer used in coupling is optional, 12v Dc Motor High Torque Low Rpm but don't use fixed rigidity coupling, the coupling no radial offset compensation quantity and installation more difficult, once the improper installation will increase the load capacity, easy to cause the bearing damage, even will cause the output shaft fracture.
Speed reducer is installed to ensure the operation of the 24v Dc Motor With Gearbox staff, including easy to close to the oil standard, the position such as ventilation and discharge of oil seal. Reducer after the installation is complete, the inspectors shall be in accordance with the order full check the accuracy of the installation position, to determine the reliability of various fasteners, etc.
In addition, the Parallel Shaft Gearbox speed reducer before running, but also prepared to run, the oil pool of vent plug off into air plug, open the oil level screw check the oil line height, add lubricating oil more than oil level screw hole to overflow, and then screw oil after a plug and identify and correct, can start commissioning.
You have to log in before you can reply Login | 立即注册

Heyshell

2024-3-29 08:59 GMT+8 , Processed in 0.038125 second(s), 21 queries .

Powered by Discuz! X2.5

© 2001-2012 Comsenz Inc.

To Top