Title: ECO Garage Floor Etching [Print this page] Author: liuer Time: 2018-8-3 21:03 Title: ECO Garage Floor Etching To ensure that your ECO garage floor project is a success requires you to prepare the floors surface properly. This means that it must be completely clean and all prior coatings of any sort must be removed. If there are any stains, they must also be removed otherwise the coating will not seal properly, it could flake and chip. Contractors usually apply a coat of waxy or silicon based sealer after installation. This should usually last for several years. However, it should be removed if you plan to apply an ECO to the floor.Obviously, if you really plan to start an ECO garage floor project then you have to decide whether your concrete floor is going to benefit from it. If done correctly then the project can be beneficial, however, if done wrong or your floor is not fit for it, you will just be wasting your time.One thing to look for in your garage is signs of a white crystal or white powder. This is moisture seeping up through the concrete, which will cause any coating to lift off. On the other hand, perhaps your floor is painted and the paint is peeling, then likely, that is exactly what will happen to your ECO garage floor project as well. There is a lot of work for this type of do-it-yourself project. If you have never completed anything like this before then it is wise to gather as much information as possible before beginning a project like this because your floor may not be right for it. " anchoring a post to a vertical wall , barefoot friendly boat deck sale ireland " " treated fencing posts kenya , outdoor tech fence iranian "
Welcome to Heyshell Games Forum (https://bbs.heyshell.com/)