Search
View: 74|Reply: 0

micro gear motor

[ Promote this link! ]

6

!threads!

0

Friends

20

Money

member

Rank: 1

Post time 2022-6-14 11:17:49 |Show all posts
When the circumference of the gear reducer speed > 12 m/S, oil lubrication, should be adopted by oil pump or central oil supply station to ~ on pressure oil supply, through the nozzle to lubricating oil into the gear tooth surface.
When v 25 m/s or less, the nozzle in the tooth meshes into or whistle while all can;
When v > 25 m/s, the nozzle should be on one side of micro gear motor a whistle out of gear tooth, in order to borrow lubricating oil cooling in time just meshing tooth, also for lubrication of gear.
General closed gear reduction motor drive, the lubrication method according to the size of circumferential speed of the gear. When the gear circumferential velocity V < 12 m/s, often used the big gear tooth submerged oil lubrication oil immersed in.
In this way, the gears in the transmission, the lubricating oil to the meshing tooth surfaces, but also the oil to the tank wall, so as to heat dissipation.
Gear oil immersed depth of visible the circumferential velocity of the gear, for straight cylindrical gear is usually not more than one tooth height, but also should not be less than 10 mm; Of cone gear tooth width should be in full, at least in half of the tooth width.
Can borrow in multistage gear drive, take the tanker oil Small Geared Motors to not immersed in the oil field of gear tooth surfaces.
How much amount of oil in the oil pool, depending on the size of the gear transmission power. For single stage drive, every passing Ikw power, need oil amount is about 0.35 ~ 0.7 Lo for multi-stage transmission, multiply need oil press series.
As for the choose and buy should consider what factors? How do we choose to use a more appropriate motor?
1. Considering the power, we need to understand Small Dc Gear Motor the many factors, including current, voltage, speed, reduction ratio, etc. In addition, also note that the transmission ratio and torque of the machine.
2. The gear motor output shaft of the radial force and axial force also need to check in a timely manner. If you're not sure, need to buy before consulting the original manufacturers, in order to understand some of the axial force and radial force of the reference standard.
You have to log in before you can reply Login | 立即注册

Heyshell

2022-8-19 07:08 GMT+8 , Processed in 0.041140 second(s), 21 queries .

Powered by Discuz! X2.5

© 2001-2012 Comsenz Inc.

To Top