The twistcabling machine can be used forbunching and stranding small cross-section cable wires and is composed of asingle twist cabling machine, a transmission line plate, a stirring cage, andan electric motor. The use of atwist cabling machine before the preparation work 1 unique tool, measuring instrumentsinto the work on the table, and check the measuring instruments are not to zero 2. Check whether the precision twistcabling machine is standard, especially the switch-off equipment and protectivecover power off protection power switch. If there are abnormalities,immediately report maintenance personnel to complete maintenance 3. according to the production planning,ready semi-finished products processing, and check whether the processing ofthe semi-finished products is work experience qualified and in line with theprocess standards, and qualified semi-finished products processing to thesingle twist cabling machine, set on the cone sleeve, and adjust the supportforce 4. According to the process standardnumber, section diameter, stranding direction hanging drive gear, adjust thestranding direction according to the process standard selected and line die on.According to the requirements of the preparation of the collection plate, checkthe winding plate is intact and the collection plate is installed in thecollection frame 5. Pull a traction line through the wirewheel, pipe mouth has been pulled to the traction wheel in the cage, and aroundthe traction wheel 3 ~ 4 turns, one end of the traction line fixed immobile inthe collection plate Twist cablingmachine operating specifications 1. the single line of railroad each overthe disconnected automatic parking equipment, through the sub-tow line, pulledto the front of the parallel die, and the electronic wire bundle screwed into ashare, across the parallel die, drag out 0.5 ~ 1.0 meters, and the parallel diefixed immobile in the mold seat 2. Connect the wire strands and tractionline, close the protective cover, delay the start of the machine, and so on.The wire knot is pulled to the winding disk, and wind disk 2 turns. Turn offthe machine, cut off the unqualified part of the knot, pull out the tractionwire, and fix the qualified knot in the coil 3. Start the machine bundle stranded 20~ 30 meters. According to the requirements of the single-line railroad, cablediameter has not been pulled thin, stranding is not in line with the processstandards, the core is not shiny, and there is no loose, to determine theaccuracy of the production of manufacturing again 4. In the case of precision twistcabling machine on, to often observe and check the single twist cabling machinewinding disk running condition and the receipt of the lined tray line rowcondition, such as abnormalities, should be an emergency stop, find thesituation and deal with the machine again after the start 5. After the end of production andmanufacturing, fill out the product manufacturing card, placed in theinspection area, such as process inspectors determine qualified and stamped,placed in the qualified products area to be pre-inspected Twist cablingmachine production quality standards of finished products Various kinds of bundle stranding cannot be a whole bunch of welding. Single-line railroads allow welding, but thesame cross-section does not allow more than two connectors. The spacing betweenthe two connectors should not be less than 300mm. The interface should be solidand clean. The bundle of the core can not be missing, disconnected, loose, orpressure stacking condition in the core of the single-line railroad error.Section diameter and stranding should be in line with the process standards. Purchase high-quality twist cablingmachine equipment. Welcome to contact the professional twist cablingmachine manufacturer - Zhaohong. We are focused on providingwire harness equipment manufacturers with wire production solutions. If youneed to establish a wire production line, Zhaohong is your best choice.
| 
Post time 2022-10-7 15:58:47
Favorites